3speedlightning
Member
- Messages
- 14
- Location
- Kilgore, Texas
ive got a savy with all aftermkt parts except for the arms & they are still stock......aint broke one yet.......i got a wasp 28......broke it in exactly as the instructions called for and have run about 1/4 gallon of hpi 20% through it......i kept the engine temp at 245 to 250F........still tight with lots of compression..........running an OS turbo p7 plug which is a medium........the problem is that i caint get it to run now.......ive found no air leaks, no bad bearings, the clutch shoes & springs are fine (matterfact new onfa 3 shoe clutch), flywheel is on tight, the nut &the collet, even a new plug..........i prime the engine, start it with the pullstart, and it will idle ok.......but.............when i give it any throttle the darn thing just flat out dies and sudden too........caint be the spacing between the spur gear & clutchbell either cause i set the mesh with a paper strip and the slipper clutch is new & adjusted so it slips when i turn it hard by hand.........somebody help me out here before i get the hammer & fix this engine real good..........ive run out of ideas & things too look for........