I had a couple of minor roll overs, and i am now missing one of my brake pads, and i have a pin on the end of my brake that has pulled out. my truck still runs fine, but the transmition does not engage. Is this pin a connector? is it easy to fix? is it common to lose a break?
-
Ask questions. Share your HPI Savage knowledge. Register TODAY!
transmition
- Thread starter cmiller
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Pineapple
Just a regular member
- Messages
- 893
- Location
- Sandy Eggo
Sounds like a grub screw-pin. Yeah its common for them to fall out or break too. Use blue loc-tight.
I don't know how you lost one brake pad though.
Welcome to the forum!
Dave
I don't know how you lost one brake pad though.
Welcome to the forum!
Dave
Blazer X
Well-Known Member
- Messages
- 973
- Location
- Hoosierland
It's probably just the brake pad that came off. It's just stuck to steel plate with an adhesive back like the slipper pad is on the spur, I've had it happen. The grub screws are common to fall out due to the heat build up and massive strain put on them during operation. Blue loctite is good but I prefer the light green from loctite as it is easier to remove when using such small hex heads like the savage has all over the truck.
