guinnessdublin
Well-Known Member
- Messages
- 1,059
- Location
- England
Have now fitted new skid plates & bumper sets as noticed even though original savage 21 type fit & there is fixing hole on side of Savage X bulk head to fix bumper post to, I wasn’t happy with 5mm gap between stopper on bumper post & end of hinge pin on upper suspension arm.
The c clip that is used to keep bumper posts in place on shock tower I tried fixing in place with a thin cable tie, but noticed it was slightly pulling them out of position.
Is there a better way or do you find they never come out & get lost when out bashing as see you have to buy whole bumper set each time just to get replacement c clips?
The c clip that is used to keep bumper posts in place on shock tower I tried fixing in place with a thin cable tie, but noticed it was slightly pulling them out of position.
Is there a better way or do you find they never come out & get lost when out bashing as see you have to buy whole bumper set each time just to get replacement c clips?