Quick dumb question. I bought a savage 4.6 tonight. Brought it home, and while I let the batteries charge, i figured I'd just tinker with the truck. I put the aa's in the truck and remote, turned them both on, and turned the steering and everything, and nothing happened. I was thinking that something should have, I know it wasn't running, but not sure what was going on, any suggestions?
-
Ask questions. Share your HPI Savage knowledge. Register TODAY!
Servo...
- Thread starter Jrmac991
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Mickey
just me
- Messages
- 3,098
- Location
- Renfrew Ontario Canada
is it a 4,6 rtr and is it the stock servo? if it is the stoc servo wont have enough torque to turn the wheels with the truck sitting stationary. exspecially on a grippy surface
- Thread starter
- #3
Yeah, it's rtr, and everything is stock. I was holding the wheels off the ground. The Antenna* was up on the truck and remote, batteries were in, and even when I gave it gas, nothing happened. I know the light was on for the remote, but not one on the truck. All of the wires looked connected. Nothing else after the batteries charge overnight, I'm gonna take it back and ask if they can help with it, but I'd rather look like an idiot on here than in person, haha. Any other info you might need to help?
Unplug the wires from the Rx & plug them back in. Then check the connector in the wire between the batteries & Rx & make sure its plugged in all the way.
Try new batteries in the Savage.
make sure your crystals are plugged in tight.
