Pulling out the Rear Bearing

[vash1774]

OK guys well I am going to do some porting on a old stock .25, so why not replace the bearings in it while its open.


So how do I get that dam rear bearing out easily?

 

[RangerRock]

heat the motor up..........most people put it in the over on 250 or 350 big difference but I cant remember and leave it in their for about 15 mins and when you take it out pull the bearing out. Have everything else already out though like the piston, sleeve, rod and stuff.

 

[vash1774]

Looks like its a motor for dinner tonight.

 

[DOOBEEWHA]

I'm not sure myself, but 350 sounds real high. I would try 250 or get somemore feedback before you proceed.

 

[4x4]

ye i did it at 250.
4x4

 

[RangerRock]

Like I said I wasn;t sure which one it was.......250 is your best bet.....350 is hot for a motor while it is running and could mess it up so I would say the 250