Hi I'm looking to convert my savage x from roto to pull, i bought a pullstart but found out it wont fit (was told before i bought it that it would on ebay) it is a four screw fitting and looks ok and mounts ok apart from the bearing not going in.
The inner diametre of the pull start is 11mm but the diametre of my one way bearing is 12mm can someone give me a part number for a pullstart that will fit plse, the bearing in now is std and the truck is more or less new. TIA
Also how can i tell if its a k or an f engine sorry bit new just know it a x 46
The inner diametre of the pull start is 11mm but the diametre of my one way bearing is 12mm can someone give me a part number for a pullstart that will fit plse, the bearing in now is std and the truck is more or less new. TIA
Also how can i tell if its a k or an f engine sorry bit new just know it a x 46
Last edited by a moderator: