Possible Servo Issues

[Preacher_Ed]

This morning I was running my Flux and noticed that it was struggling to turn. The wheels don't go full travel in either direction. When I pick the car up the servo is able to turn the wheels. Everything looks fine and as long as the truck is off the ground, the servo seems to turn the wheels fine, but when the weight of the truck is on the wheels very little happens. Is this a symptom that my servo is going bad?

 

[Jam Racing 1]

maybe so, did ya make sure the bellcranks are tignt and the servosaver didnt loosen up ? prolly just a weak stock servo and ya may wanna upgrade to a better one, hope ya get it figgered out ed......

 

[Preacher_Ed]

Thanks, Jam. I'm suspecting the servo because everything is fine with the weight off the front wheels. I'm going on vacation next week, so I'll get a new servo ordered and it will be here when I return.

 

[Mickey]

Could be the bec in the esc as well. If you have a volt meter measure the voltage going to the servo on the black and red wire