My savage x start up issue

[woahproblems]

Please watch - http://www.youtube.com/watch?v=Ab1wn0aa7u8

Feedback please?

 

[AllanQ]

Welcome to the forum!

 

[Fx]

I don't see a problem. What are you saying you think is wrong?

 

[maximusraylius]

its just the idles a tad to low... turn it up an 1/8th turn should be fine then turn back down so the truck don't roll away from you... as for air leaks its not leaking just air bubbles from tank getting empty.. itll clear up when you prim it and start it ,,,as for temps ...ignore um... as long as you got good smoke at wot.. your safe .. each mill runs at dif temps due to fuel and tuneing ect.. just lean it out but watch for good smoke trail and your good...hope this helped...

 

[AllanQ]

when I first checked it, the vid did not load up. looks like its working now, at least for me.

 

[maximusraylius]

is there enough gas in the tank to even load up?lolthat would explane the bubbles in the line ...

 

[Bankrupter]

low idle and fat lsn is all I can hear. do the lsn first. you talked about MTL only fill to the half way point on the tank and tune it at that point. then just run if from half tank down it will keep a better tune.