mounting the rX

[JESTUS]

I am not sure if this is where to pose this question but here goes.
It seems to me there should be enough room to mount the stearing servo and the rx under the tank plate such as the PRC 125. I just must not be smart enough to figure the way out. So I need help. Once I get this block broken then I can get this build started. Well I can start buying parts at least.

 

[orcusomega]

Well, it all depends 🙂

For me, I put mine in a balloon and zip-tied it to side of my TVP. I put little pads on the receiver to minimize vibrations, and this should work well. There are other ways, including using other radio boxes, etc.

Hope this helps.

Bob