wildchild27
DR. DISASTER
- Messages
- 748
- Location
- Etna Green, IN
hey guys hows it goin?, well ive been working on my own end-bleed pipe. (YES THERE IS VID) lol. parts used: tais badboy pipe (imho not a good pipe) hack saw, tig welder.
1. cut stinger off and support brace.
2. cut off exhaust hanger mount leaving end open (hole for exhaust)
3. place exhaust mount over old exit port (weld in place as hole plug)
4.take an 8mm tube 3\8in long over new exit port (weld in place )
5.mount to truck and set gap between header (preferance)
6. tune mill and bash!!!
vid link: www.youtube.com\quietone2733
title: custom tuned pipe test
thnx,
eric
1. cut stinger off and support brace.
2. cut off exhaust hanger mount leaving end open (hole for exhaust)
3. place exhaust mount over old exit port (weld in place as hole plug)
4.take an 8mm tube 3\8in long over new exit port (weld in place )
5.mount to truck and set gap between header (preferance)
6. tune mill and bash!!!
vid link: www.youtube.com\quietone2733
title: custom tuned pipe test
thnx,
eric