rhett7660
Member
- Messages
- 25
- Location
- Lakewood, CA
Hi all..
I looked thru the manual and looked thru some of the threads but I didn't find the answer.
Here is the question:
On the back of the engine where the roto start pin goes into is this supposed to be loose? I looked at and the two screws that I can see do not go all the way thru the starter. Is this normal? It almost feels like it is going to come off, it hasn't but it feels like it.
Just wanting to make sure I didn't break anything. It starts up and runs fine.
Thanks
R~
I looked thru the manual and looked thru some of the threads but I didn't find the answer.
Here is the question:
On the back of the engine where the roto start pin goes into is this supposed to be loose? I looked at and the two screws that I can see do not go all the way thru the starter. Is this normal? It almost feels like it is going to come off, it hasn't but it feels like it.
Just wanting to make sure I didn't break anything. It starts up and runs fine.
Thanks
R~