Pope
Well-Known Member
- Messages
- 3,442
- Location
- Columbus Ohio
I had my servo ext cut in half over the weekend and figured I would make a quick how to on fixing it. This can be used on servo's, ext's, ESC's, on off switchs just about anything.
1) Cut out bad section of wire. Seperate each wire and strip back.
2) put a peice of heat shrink big enough to fit over all three wires on and slide it to the end of the wire as far from the solder points as possible. Than use three thiner peices of heat shrink over each of the wires to be soldered.
3) Match up wires and twist them together, Than solder the same as you would tin the end of a wire.
4) move smaller heat shrink over each joint and shrink.
5) move larger heat shrink down over all three joints and shrink to hold the wires together as one. ( I did not do this as I was out of large heat shrink)
1) Cut out bad section of wire. Seperate each wire and strip back.
2) put a peice of heat shrink big enough to fit over all three wires on and slide it to the end of the wire as far from the solder points as possible. Than use three thiner peices of heat shrink over each of the wires to be soldered.
3) Match up wires and twist them together, Than solder the same as you would tin the end of a wire.
4) move smaller heat shrink over each joint and shrink.
5) move larger heat shrink down over all three joints and shrink to hold the wires together as one. ( I did not do this as I was out of large heat shrink)