Homemade skidplate

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

RangerRock

Well-Known Member
Messages
1,985
I was wanting to make a skid but don't know what to use to hlod it to the frame? i thought about a pop-ribit but then it would be hard to remove and then thought about regular screws..... what do yall think... it's for the middle:confused:
 
buy 2 more of those plastic braces that go acroos the frame at the back of both front and back skids...then you will need 8 screws..4 for each bar(2 to the TVP's and 2 into the skid it's self)..and it should mount up and easy to remove as it's just screws holding it on.
 
how about this: made it today!:)


See 3 posts down for a better pic ;)
 
Last edited by a moderator:
well to be hones I really don't kow hopped all i know is it is metal gears and i paid 50 bucks for it andhaven't had any problems.
 
100_0497-1.jpg
[/IMG] hope this is better
 
ok My steering servo is a Hobbico Commander Super Torque CS 70. if that helps any Hopped .. also thanks X
 
I Used Some Thin Metal And The Stock Screws Along With A Drill And A Hammer..it Was Easy
 

Latest posts

Members online

No members online now.
Back
Top