FLM Flux pictures

[kpj313]

Well I got it back today from Jamie at FLM and just finished putting the cen diffs in and just waiting on a RPM Receiver Box, or if anybody has any other ideas where to mount the Receiver, or a different receiver box all together LMK!
Here are some more detailed pics.
Edit to add close up of PRC roll bar # PRC122

 

[Scott]

Looks sweet bud...

 

[Larsenracing]

Nice looking set up. I really like the Roll Bar! Go PRC, LOL.

Where is your steering servo?

I would just double side tape the receiver to the top of the Servo Plate and add an antenna mount to it near the stock location from the Stock Radio Box so you can use the same hole in your lid.

 

[kpj313]

The stock servo took a crapper on me, it just stopped working and would only move a few mm either way. HPI is sending out a replacement but I have Hitec HS-645MG to through in for now. I'm just a little leery about not having any protection for the receiver like that, $90 a pop for the futaba receiver I'd like to cover that thing up...

 

[Larsenracing]

I hear ya but it will be protected enough and will not get damaged sitting down between the TVP's. LOL, your running Electric there should be little reason your not running a lid, HEHE.

Ya know the only damn thing HPI did that bothers me on this truck is the cheap Zip Tie holding down the ESC. Couldn't they have found a better more professional way to strap that sucker down being's it's an RTR Truck.

 

[Jeremy]

Nice truck man !

 

[frddyj]

A flux with flm & larz's carbon fiber? now your talkin' :evilrocker:

 

[Combuster]

man that flux looks pretty cool with those TVPs