SwampDawg
Well-Known Member
- Messages
- 501
- Location
- Interior BC
After looking at this thing for years collecting dust ive decided to take on yet another project (not like i already have enough going on) LOL
After tearing down the top deck along with the nitro engine, fuel cell soforth here is the doner!
Tearing into the drivetrain now....
Next job is to trim a small portion of the chassis where the spurgear exits on the chassis to accomodate for the difference in spacing.
After using thick CA to bond the oneway bearing from moving, and assembling things as shown in pic above. Most of the components were removed and a bushing to space out the spurgear.
If this works out as I'm sure i can manage this, itll make a sweet driftR 😀
All wheel drive
Alloy chassis
Ackerman steering system
Full adjustment for Toe-in/out, Camber, Caster etc.
Still lots to do yet but I'm just about to lock out the rear differential.
more to come!!
After tearing down the top deck along with the nitro engine, fuel cell soforth here is the doner!
Tearing into the drivetrain now....
Next job is to trim a small portion of the chassis where the spurgear exits on the chassis to accomodate for the difference in spacing.
After using thick CA to bond the oneway bearing from moving, and assembling things as shown in pic above. Most of the components were removed and a bushing to space out the spurgear.
If this works out as I'm sure i can manage this, itll make a sweet driftR 😀
All wheel drive
Alloy chassis
Ackerman steering system
Full adjustment for Toe-in/out, Camber, Caster etc.
Still lots to do yet but I'm just about to lock out the rear differential.
more to come!!
