Gazzman
Well-Known Member
- Messages
- 912
- Location
- Haywards Heath, Untied Kingdom
Been looking to change the carb on one of my K5.9 mills. Been looking at the Force CM3613-3 carb, I am assuming it's the same carb as what the F5.9 uses as the Force .36 and the F5.9 are one of the same. The carb inlets seem to be the same at 9.5mm but are they the same diameter at the end that pushes into the opening in the crankcase. if anyone has any input or feedback about this I would be very grateful.
There are 2 reasons I wish to do this
1- is to loose the middle needle as the rubbers have gone hard and the needle moves with vibration
2- this carb is 2/3rd the price of the K5.9 one.
There are 2 reasons I wish to do this
1- is to loose the middle needle as the rubbers have gone hard and the needle moves with vibration
2- this carb is 2/3rd the price of the K5.9 one.