I was thinking about that rc solutions roll cage aswell but then though to much weight back on top killing my LCG. I think i am passing on the roll cage. But ya, idea is to make a supr strong basher.
could i possible run 8 of those IRC shocks? that would be badass. I forgo about that picco p3 i heard its great for low-mid range power as the lpr is a bit more top end. Also heard great things about Buku Pipe.
Whats the deal with OFNA linkage? I need to add a HumpPak.
First off I have a stock savage that I am going to keep stock for a bit more but planning to do a full basher buildup. I do hae a hitec steering servo already though and the heavy dogbones. I have many questions I am hoping you guys can shed some light on aswell as what the progress of my...
ok so update... I HAD to lean out the HSN untill I discarded some of the fuel, So i am thinking during startup its flooding a bit hence when I give more fuel it dies.
Bigger question is why is this happeing? GLOW PLUG not operating right due to cold?
P.S. I had to richen the HSN once...
Ok, I dunno if its outside temps or a fuel issue where there is not enough or flooding. But basically what is happening is: i prime - then crank it over - it will start normally right away. If i try to give any gas soon after it dies. barely will crawl even an inch then die out.
do I...
ok so i see one of my stock shock cap is blown open and oil everywhere...
I tear down a bit of the truck to do a clean and repair the shock, next thing I know the other 7 shocks that LOOK to be fine are quite the opposite. 6 of the remaining shock have loose caps and no oil or very little...
i think i am going lpr or picco, i heard picco is better low-mid range and lpr has better top end. I would rather the lower-mid power as I bash and not race.
I know nothing about whats good vs whats not, pretty new to the hobbie.
can you pros suggest some good motors that is under the $180.00 range? its for bashing primarly.
sounds good, i know anything beadlock is going to weigh in more then glued wheels I also hear about the beadlock not holding very well andtires comming apart.
how do I choose whats right for me and my truck?
Is it what ever i like? Is there a right and wrong size/tread?
can u guys suggest some setups?
I know stock hub is 17mm if that helps.
Difference between foams?
I am a basher aswell so bes setup for bashing is what I want...
on a side note, I was looking at the site and there is other stuff I want to buy aswell
1. HPI Savage Dual Disk Brake Set - #87150
2. HPI Ribbed Tuned Pipe, Black - #86186
3. RPM A-Arms for Savage, RF or LR, Black - #82002
3. RPM A-Arms for Savage, LF or RR, Black - #82012
4...
New member here because of this post :D plus looks like a great group. I WANT IN FOR 2 SETS (8 total) PLUS OIL PLEASE! 150% I AM IN!!!
I know they not relesed yet. Oh and I am in Canada Ontario.