Recent content by REDSAVAGEMAN

  1. REDSAVAGEMAN

    SavageX 4.6 super gear(spur gear)

    spurs Hey chronic ( nice name too ) The easiest way to mesh your gears is to take a piece of notebook paper and cut a 1 inch by 6 inch strip and fold long ways in half ( so it is 1/2 inch by 6 ) Feed it into your gears and take a screwdriver and push the engine block as much as possible...
  2. REDSAVAGEMAN

    Savage Evilution

    You will absolutely love the Axial !!!!!!
  3. REDSAVAGEMAN

    Which is more powerful the legend K4.6 or the or the rookie F4.6

    It looks as though you have your answer, but I want to complicate things by telling you to buy the Axial .28 instead. They are both made by the same manufacturer and the Axial is about $70 cheaper. I just purchased and broke in the 1 spec engine and I absolutely love it. Good top end and you can...
  4. REDSAVAGEMAN

    A Myth??

    yO CRASH......i AM ONLY 17 YRS OLD. shhhhhhh. Seriosly 12 miles away Hey 89 Mine starts to idle a little higher too. Hope I can help. I noticed the same thing you are talkin' bout so I keep my idle just a tad low and start my sav with a little more throttle trim. You will prob keep the trim...
  5. REDSAVAGEMAN

    A Myth??

    THANKS EVERYONE - I just got this down in the 260's with a couple adjustments. I try to answer all the questions in this thread....... I am running medium plug I could use a new exhaust gasket I have about 7 tanks through it now no air leaks bolts are tight. I figured I would get...
  6. REDSAVAGEMAN

    A Myth??

    So i get this new Axial .28 right ? There is so much bottom end power, but whe I start to get to the 2nd gear shift point it boggs down. When i lean it out it performs great and shifts, but gets up to 300 degrees. I hate tuning by temp b/c I spend more time tuning than driving. Do I: A)...
  7. REDSAVAGEMAN

    Diff Fluid???????

    Thanks again guys !
  8. REDSAVAGEMAN

    Diff Fluid???????

    Thats what i figured, but HPI said grease in the hub which I thought was odd. Anyways.....What kind of fluid shoud I use ?
  9. REDSAVAGEMAN

    Diff Fluid???????

    I have heard conflicting stories on running fluid in the diffs.......HPI says to use grease, but some guys say to use fluid. What should I use ? I will be replacing my old diffs tonight and wanted to make sure I did it right. So.........Fluid ? No Fluid ? If so what kind ? Thanks again guys
  10. REDSAVAGEMAN

    More Torque Bad Diff ????????

    where are you from ? IL ?
  11. REDSAVAGEMAN

    More Torque Bad Diff ????????

    Once again.......Thanks Cransh and JT. I will open everthing up tonight to take a look
  12. REDSAVAGEMAN

    More Torque Bad Diff ????????

    I knew I could count count on you Crash ! I am actually really good at the spur /clutch meshing and I can not figure out why people have problems with it, but I always ALWAYS keep an extra spur around. Do you have a link to the diffs you speak so highly of ? P.S spent about $270 at leisure...
  13. REDSAVAGEMAN

    More Torque Bad Diff ????????

    As posted in a previous thread. I finished the breakin on my new Axial.28 and it has so much more power than my HPI .25 and I think that is where the problem is. It was not much of a problem during breaking b/c of the low RPMs, but under full throttlye (5th tank) You can hear a loud...
  14. REDSAVAGEMAN

    New Axial .28

    Thanks for letting me know.
  15. REDSAVAGEMAN

    New Axial .28

    Hey guys I just got an Axial .28 and completed the break in cycle. I totally understand how to tune the HPI engines, but I need some info on the "mid range" needle on the axials. I am slowly starting to lean it out and wanted to know if I should adjust the mid range needle. Thanks
See more
Back
Top