Recent content by MadH00ter

  1. M

    HPI Warlock's vs Maximizer's : Weight?

    What would the weight difference be between the two rims? Would Maximizer's + Badlands or Dirt Bonz be heavy on my well broken in k4.6 ?
  2. M

    Need a little wheel and tire advice..

    Nevermind guys, found the info through the ol trusty forum search.. thanks for the replies though! as always you all rock...
  3. M

    Need a little wheel and tire advice..

    Oh, any ideas about maximizers and dirt bones fitting together?
  4. M

    Need a little wheel and tire advice..

    Cool, thanks for the info. Just gotta wait until I have the place to my self for a couple of hours and will give it a go
  5. M

    Need a little wheel and tire advice..

    Hey Guys, I've got a set of (I think factory) HPI Warlock wheels with Dirt Bonz. Currently they shake like mad because of a good soaking, even though I have dried them as much as possible. I really like the Dirt Bonz and was wondering if they would fit on the Maximizer 1732 rims? What is the...
  6. M

    savage 1/5 short course truck!!!!

    Savage 5T (Short Course/Desert Racer) http://www.hpiracing.co.jp/contents/kits/savage5t/index2.html http://www.hpiracing.co.jp/contents/kits/savage5t/inst_a.html
  7. M

    savage 1/5 short course truck!!!!

    +1....!!!!
  8. M

    savage 1/5 short course truck!!!!

    I Want! I Want! I Want! I Want!
  9. M

    Curious about drive shaft parts..

    #86269 - UNIVERSAL DOGBONE 8x87mm - Are these eplacements for the front or rear drive shaft going from trans to diff #86270 - UNIVERSAL DOGBONE 8x93mm - Are these replacements for the front or reard rive shaft going from trans to diff #87239 Universal Joints 9x162mm (PAIR) ) - And these I...
  10. M

    Engine Tuning Blues

    Dunno 'bout you, but I can grab the roll bar (body is usually off the truck for me due to my tuning woes) of my truck with me remote in hand. and when starting with wheels on the ground, I just put my left foot in front of the truck.. So back to tuning, I can get it to idle pretty well now (I...
  11. M

    Engine Tuning Blues

    Nah, she's as loose as a lady of the night...
  12. M

    Engine Tuning Blues

    Perfect! that explains why all my tuning attempts have failed thus far! Lsn until I can idle for however long I want, and then start following your guide for the rest. Thanks again all, sorry it took so many posts to get to this point.
  13. M

    Engine Tuning Blues

    Since I've already started leaning the HSN 1/4 +/- without touching the LSN. Should I start over and set back to flush. Then start leaning the LSN until it'll idle for 10-15 seconds. Then work on warming it up with WOT runs and then tune the HSN per the guide followed by tuning LSN per the...
  14. M

    Engine Tuning Blues

    PureNitro: If your engine won't idle at all, start by leaning the LSN at 1/12 turns until it will idle on it's own. Should I do this before working on the HSN ?
  15. M

    Engine Tuning Blues

    It'll idle, just boggs quickly and dies if I don't pinch the carb line to stop the fuel flow. As soon as I pinch the line, it'll start reving back up at which point I stop pinching, try a tiny bit of throttle, which boggs it right back down, then I do 1/12 turn leaner on HSN and try again.. when...
See more
Back
Top