Hey Guys, I've got a set of (I think factory) HPI Warlock wheels with Dirt Bonz. Currently they shake like mad because of a good soaking, even though I have dried them as much as possible.
I really like the Dirt Bonz and was wondering if they would fit on the Maximizer 1732 rims?
What is the...
#86269 - UNIVERSAL DOGBONE 8x87mm - Are these eplacements for the front or rear drive shaft going from trans to diff
#86270 - UNIVERSAL DOGBONE 8x93mm - Are these replacements for the front or reard rive shaft going from trans to diff
#87239 Universal Joints 9x162mm (PAIR) ) - And these I...
Dunno 'bout you, but I can grab the roll bar (body is usually off the truck for me due to my tuning woes) of my truck with me remote in hand. and when starting with wheels on the ground, I just put my left foot in front of the truck..
So back to tuning, I can get it to idle pretty well now (I...
Perfect! that explains why all my tuning attempts have failed thus far!
Lsn until I can idle for however long I want, and then start following your guide for the rest.
Thanks again all, sorry it took so many posts to get to this point.
Since I've already started leaning the HSN 1/4 +/- without touching the LSN. Should I start over and set back to flush. Then start leaning the LSN until it'll idle for 10-15 seconds. Then work on warming it up with WOT runs and then tune the HSN per the guide followed by tuning LSN per the...
PureNitro: If your engine won't idle at all, start by leaning the LSN at 1/12 turns until it will idle on it's own.
Should I do this before working on the HSN ?
It'll idle, just boggs quickly and dies if I don't pinch the carb line to stop the fuel flow. As soon as I pinch the line, it'll start reving back up at which point I stop pinching, try a tiny bit of throttle, which boggs it right back down, then I do 1/12 turn leaner on HSN and try again.. when...
The plug is brand new. I had a tune issue previously, needles must have out of whack, rich LSN and lean HSN. Was distorting brand new plugs and wrecking them. I'll keep going then, probably close now to getting it to run without it flooding and shutting the engine down.
Thanks for letting me...
Hey guys, been struggling with tuning my truck. Decided to go back to factory settings and re-tune with PureNitro's tuning guide. I have a used truck, x ss, engine is probably already well broken in (K4.6).
The problem I'm having is getting it started and keeping it running to get the temp up a...
Thanks for the info and suggestions guys! I took it to my LHS and they were somehow able to recharge them for me! I don't have a charger cable in the truck :-(
Anyone know the part number for that? I have the old Hitec AM radio that orriginally came with my used X SS
Nah, unfortunetly all I have is the ProphetSport charger. Would the pack be pretty well dead though if it was left on for about 12 hours? what kind of charger are you talking about (wire charger) ?