Recent content by justbart2002

  1. J

    Problem with my rotostarter

    I have found a solution for my problem. I have changed the OWB and after half a gallon the problem popped again and it was slipping like hell. The solution was very simple i began pre heating and after 20 seconds of preheating the car starts at the first button push. I have found the best...
  2. J

    Engine Preheat In Middle of nowhere

    I have found the best solution to pre heat in the field...i am using a gas letcon (i don't know if you understand what it is). It's a device used in electronics for soldering little parts. It is very small and it creates a little but intense flame. I will give u a link to understand how it looks...
  3. J

    Problem with my rotostarter

    hi A few days ago i have noticed that the pice of plastic where the head of the rotostarter goes in (i think it's called backplate) it was moving when i was starting the truck and i have thighten the two screwes that i have seen without removing the engine. Today when i have started the...
  4. J

    Problem with my carb

    I don't know how to add pictures on this thread. Please help
  5. J

    Problem with my carb

    This is a picture with the glow plug
  6. J

    Problem with my carb

    file:///D:/Do***ents%20and%20Settings/cbaba/Desktop/tv/Picture%20021.jpg
  7. J

    Problem with my carb

    I relly don't understand this coulours...there are colours that i don't understand in my own languase...so you've put a big ahhhh? on my lips with that dark almond :) With the next occasion i'll take a picture
  8. J

    Problem with my carb

    I have found the problem...it was the HSN..it was way too lean. The thing was that i was making a mistake ...when i was tuning the LSN the idle was decresing (when leaning LSN) and instead of turning the idle i was leaning the HSN... The thing was that i have started from factory settings and...
  9. J

    Problem with my carb

    So if the idle is set to high it's posible to act like this...and i have to lower it till the edge of not killing my engine?
  10. J

    Problem with my carb

    I have the next problem: In the first half of the tank everything is ok , after that the problem begines. When i brake the engines tends to choke after that the idle is ok. If i let it be it idels ok , i tried the LSN no luck with that, I have shortend the fuel line from tank to carb no luck...
  11. J

    Why even have a Mid-Range Needle ??

    I hope i don't sound stupid...but what is a mill? "at your experience level, you shouldnt be runnin a sport mill anyway"
  12. J

    pre heat

    How exactly do you pre heat an engine? and i was told to put after run oil after every exit...is this ok?
  13. J

    Black Tremor Wheels/Goliath tires with my new lid!

    What's an offset rim?
  14. J

    Black Tremor Wheels/Goliath tires with my new lid!

    I don't want to race. I'm playing in a field with lots of tall grass and dirt, and i think the terra pins being bigger would be more helpfull in the grass and in climbing a hill with grass.
  15. J

    Black Tremor Wheels/Goliath tires with my new lid!

    I suposse it's the same story with the terra pin for my stock savage (F4.6 motor)
See more
Back
Top