Please help I was installing a tigerstarter pulled the plate off and there was a small pin that fell out,also which side of the groove on the piston be facing?
I looked at exploded views and did'nt find that pin.Anyone have a link better than HPI,or instructions on engine rebuild.yhe pin looks...
Vaccum leak,not pulling or pushing fuel from the tank,LHS here I come,I read the post about using perm. copper header gromet is trash gonna use that method. thx again every one.
Now It fires up runs for maybe two seconds and shuts off bought new fuel line and removed fuel filter. I am gonna get a rotostart easier on the hands.
thanks to all for the info.
hey guys I think I fixed my steering problem,but now the engine won't start.I adusted the h/s,L/s needles per factory settings,fresh glow plug I have a pull start and I have tried everything I know to do.I drove the car before I bought it do I know It will run.Carb problem?
Help please
Next question. I am running a traxxas 3 channel receiver I had laying around,will this cause issues with steering travel?My servo only moves slightly left or right,I checked for binding,recentered servo,I am using the HPI transmitter?
ok,got everything hooked up,but now my front wheels only turn maybe 1/4" each way,aggggggggg,we'll go over it again tomorrow.Engine runs good hate to sell it BUT...........
Thanks guys,waiting on parts,if I don't figure it out,I'll drive 50 miles to Citrus Springs and let LHS fix It.Exploded view was for a Savage 35.Bellcrank and stock steering is what I'm looking at now.
thanks support has been outstanding!
Still can't figure out the Savage linkage,I have searched,looked at exploded views. Does any one have a link with step by step instructions or a pic without front skid plate installed.I can usually figure these things out. Previous owner stripped out a couple of screws which makes it worse...