Recent content by Cory976

  1. C

    Force .26 bolt into Savage "X"?

    No. The holes do not line up. But I found a GPM engine mount with adjustable slots that fits for about $15! So I'm going to swap the pull-start from the .25 to the .26. (hopefully that will bolt on!) and see if my local R/C hobbies have one in stock 2morow.
  2. C

    Force .26 bolt into Savage "X"?

    Nope it does'nt work. I pulled my motors out, ther Force .26 motor does not line up with the HPI motor mount. The bolt holes don't line up! Darn. Anyone know of a motor mount that will fit a Force .26 motor onto a motor mount that fits a savage?
  3. C

    Force .26 bolt into Savage "X"?

    I have an OFNA Force .26 Big block from a Ultra Comp MBX Buggy. Will this motor bolt directly into my Savage "X"? It looks like the only thing I'l have to do is swap out the carburators. Can I swap the carb from the 4.1 (.25) motor to the Force .26? Anyone have this motor in their Savage...
  4. C

    No low end torque! Is my motor a lemon?

    Slipper : Locked down Gearing : 15/49 Fuel: 20% O'Donnel Plug : McCoy MC 59 Shock oil : Stock 40wt Pipe : HPI chrome tuned polished pipe Altitude : 5800 ftabove sea level Temps -Engine 250-275 degrees
  5. C

    No low end torque! Is my motor a lemon?

    When I lean the LSN out, it just cuts out, like it's starving for fuel.
  6. C

    No low end torque! Is my motor a lemon?

    No matter what I do I cannot get my savage X with a 4.1 Big Block to even come close to pulling a wheelie!:mad: Everyone says to just keep leaning the LSN out till it does but it really does'nt do much. When I do keep leaning it more and more, it just cuts out while accelerating, so I know I'm...
  7. C

    X won't pull a wheelie.

    Leaning out LSN DID NOT HELP! O.k, I've leaned my LSN to the point to where the idle became erratic and would cut out after I gunned the trigger, and it made, maybe like a 10% difference!:mad: Its just like "rrrrrrrrr" rrrrrrrrrr" when it takes off,(almost like it's overpowereing or slipping...
  8. C

    X won't pull a wheelie.

    Also, I heard the .25 has a very generous head clearance at 0.029 w/ 3 0.008 shims installed. Would removing one shim from underneath the head help?
  9. C

    X won't pull a wheelie.

    I have about 9 tanks of 20% O'Donnel racing fuel through my Savage "X". I'm having a hard time even pulling or popping a small wheelie. My HSN seems to be set perfectly. It has great midrange and top end, but very sluggish from a dead stop on the low end. I've leaned:( my LSN out about 1/2...
See more
Back
Top