-
Ask questions. Share your HPI Savage knowledge. Register TODAY!
Recent content by cOLD
-
What did you do to your HPI Savage today?
Put my truck together after being in pieces for over 11 years. Got it tuned pretty well, everything works! Hoping to take it to my favorite field after work this week.- cOLD
- Post #1,073
- Forum: HPI Savage
-
Diff part question.
sweet, I do have some extra wheel pins. thanks!- cOLD
- Post #3
- Forum: Chassis & Drivetrain
-
Diff part question.
I looked around the forums and the SS manual, but couldn't find a solution... I took apart my rear diff because it didn't seem to be driving either rear wheel. When I got it out, one of the outdrives basicaly pulled out free. After opening up the diff, I found that the pinion gear ws in pieces...- cOLD
- Thread
- Replies: 2
- Forum: Chassis & Drivetrain
-
why preheat?
It's about a mile from my house to the place I usually frequent, good thing about living in south texas, plenty of free space. :)- cOLD
- Post #33
- Forum: Nitro Engines
-
Top 10 Recommended Savage Upgrades
This is a great thread, thank you again for all the great info here...HPI should be paying you guys for customer support! :) I have a question, I have pretty much done the majority of the top 10 upgrades on the top of the thread here.. My question is, what would you guys consider 11-20? or even...- cOLD
- Post #53
- Forum: RC Builds and Projects
-
why preheat?
After last weekend, I am sold on the idea of preheating the motor. I spent the better part of an hour getting the truck started and running warm enough to use the throttle... It doesn't get too cold down here very often and the cheapest 12v hair dryer I have found is about $15 + shipping...so I...- cOLD
- Post #30
- Forum: Nitro Engines
-
How-Not-To-Section
lol, yeah...I am cruising that before I get my new power chair ;)- cOLD
- Post #43
- Forum: HPI Savage
-
How-Not-To-Section
Went out to run yesterday, was really cold for south texas, I was having a heck of a time getting it to sputter...anyway, I am slowly wearing out my roto-start battery, wondering why the thing won't even sputter..I was trying to adjust the needles, idle..I even pulled the glow plug a couple...- cOLD
- Post #41
- Forum: HPI Savage
-
Need help keeping engine running.
well, i did what you said Frddy and watched that video about 10 times today. When I got home I started at flush and I was turning both needles an 1/8 turn for about half a turn then concentrated on the HSN until I could tell it was too lean... was sputtering and bogging like crazy on 3/4...- cOLD
- Post #8
- Forum: Nitro Engines
-
Need help keeping engine running.
I was messing with the truck tonight and I noticed I can turn the flywheel over with my middle finger while the motor is installed in the truck. I was reading the website of RayRacing that was recommended in the shoutbox and he was saying that his pinch service would restore idle. I think I am...- cOLD
- Post #7
- Forum: Nitro Engines
-
Need help keeping engine running.
first a little butter... Just want to say THANK YOU for all the help you guys give. I feel bad for always asking questions, but you guys are the best help desk I have had contact with :) That being said, surprise! I need some help. I have a Savage X 4.6 that I bought used and I had a lot of...- cOLD
- Thread
- Replies: 8
- Forum: Nitro Engines