BlazerWray
New Member
- Messages
- 3
Having a hell of a time finding starter shaft #15234 for my older 5.9, discontinued part on hpi website and after reading form on this site found out its been a problem for a long time. I dug around on the new F5.9 engine and it shows a similar set up to an old 4.6 I used to run. My question is has anyone tried the conversion yet? It seems very possible to me it would work would if the sizing is the same, just have to buy all the parts I'm guessing. Got a pictures of the of owners manual, part numbers; #1433, #1432, #117263, #1072829 and might not need but also #120277.
Figured I'd see if anyone has successfully done it yet before I spend the money. Thanks in advance.
Figured I'd see if anyone has successfully done it yet before I spend the money. Thanks in advance.