Search results

  1. T

    Broke a sway bar end link is there a metal upgrade or something stronger .

    Sway bar link goes from bar to the control arm .
  2. T

    Broke a sway bar end link is there a metal upgrade or something stronger .

    My son and I were bashing this weekend and broke the seat bar link . Anytime something breaks I always try to go to a stronger setup so is there a metal end link that will work .
  3. T

    Tired of one way bearing failures is there a better option

    Mine is on the outside of the engine
  4. T

    Tired of one way bearing failures is there a better option

    Is there a fix to eliminate the one way bearing for the roto start . I can get maybe 20 starts out of mine before they free spin and I have to pull the engine and clean it or replace it . I thought I saw a post about drilling and pinning the bearing to the shaft so it is always engaged to the...
  5. T

    Your Opinions on Aluminum Steering Bellcranks

    I have integy one I upgraded to it for strength as well as to get ball bearings instead of plastic bushings I had a lot of slop in my steering from the plastic pieces . I let my 7 year old drive it so whenever he wrecks/breaks parts I just upgrade to stronger if I can .
  6. T

    OFNA equivalent linkage set up bits, what else do I need?

    21t and 25t are the tooth count or splines on the servo motor where the arm mounts . You can look up the part # for your servo and should be able to find splines count . I haven't done this mod yet one that I am interested in as well .
  7. T

    Does anyone sell a tank mod kit ?

    Looking to swap to a smaller tank or do a proven fix to help lean conditions when my tank gets low on my x. I have read everything from midtank mod( don't want to do have a cage on my x) run long fuel lines from front to back to carb, primer pump bulb , large fuel filter or swap to a 125cc tank...
  8. T

    2nd broken cover plate from roto start .

    I have had the threaded portion of the cover plate break twice now and all the bolts back out of the other 2 . I use lockite 242 on all of them and they still break/ back out . I have the 3 bolt roto start but also see there is a 4 bolt roto start with the center drive and no one way bearing for...
  9. T

    Need to know antenna length tf-3 27 hz receiver

    I actually ordered a 2.4 GHz radio with the throttle safety to stop a runaway incident which I was always worried about since I let my little boy also drive the truck .plus now I can use the 30/70 throttle steps to slow it down some when he uses it .
  10. T

    Need to know antenna length tf-3 27 hz receiver

    My antenna got damaged and I need to repair it . What gauge wire and length does it need to be ? Can I solder a piece onto what's left or should I replace it from the reciever board ? Would rather just add the missing length as I have a cage on my truck .
  11. T

    17mm Hex Adapters

    I am also running the hot racing setup . I kept loosing wheels even with new nylock nuts to secure the rim to the hub . After the change to the hot racing setup no problems
Back
Top