Search results

  1. battyone

    Lrp .28 air leak?

    yea checked piston, and seems fine no marks on top either
  2. battyone

    Lrp .28 air leak?

    thanks will check it out fixed idle needle air leak but keep blowing glow plugs so i suspect i need those shims as it still has an issue with idling
  3. battyone

    Lrp .28 air leak?

    Have the same motor also bought 2nd hand in a savage X and discovered a missing head bolt which after removing head to check if it was broken only to discover there were no shims either. The engine seems to run ok(replaced missing head bolt) but still needs a loose idle screw to...
  4. battyone

    measuring rim offset

    Still new to this and am a bit confused on where the offset is measured with rims, Also what is the measurement for the standard warlock rims offset so i have something to compare with when looking for other types and styles? I would like to go with a slightly...
  5. battyone

    no shifting

    I found my shift set screw was all the way in and of course there was no shifting after resetting grub screw out to proper factory setting i still have no shifting. engine has the rpm's but am running a short course on a thick lawn area. after reviewing...
  6. battyone

    Half tank lean

    am going to make a mini "coolcan" just coil up some fuel tubing inside a camera film cannister and try mounting to the rear of shock tower just above carby inlet level. A rather inexpensive experiment too try and cheat the "fluid dynamics of 1/2 tank leaning issue"...
  7. battyone

    Body Pin Handles???????

    I made some body clip handles from very small zip ties and used heat shrink to mold the looped zip ties into a small tassle just use heat shrink just large enough to slip over the knuckle part of the zip tie, and about 3 mm longer than the loop. use brightly...
View older results
Back
Top