Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Yes. so i don't need to remove anything else? just the screws that holds the tranny?Do you mean the two screws that hold the pads onto the tranny have one loose? The easiest way to tighten them is to remove the tranny I have found.
The breaks are loose. ok will try 1 of the method.You can also get at the brakes if you remove the entire rear bulk/assembly and the engine. Or, if you take off one TVP and the screws to the other side of the trans. To remove the rear, I don't take off a TVP, I just remove the upper rear bolts going through the bulkhead and loosen the engine plate bolts, then that usually gives enough flex in the TVP to pop the rear end out in one chunk.
Are the screws actually loose or do you just need to adjust your linkage to take up some of the slack so the brakes grab again?
Ya go with a electric motor, it has great brakesLong story short, was too busy and only manage to get the thing running now. Breaks was working fine for about 10 min or so and the breaks were loose again, to completely no breaking power. Any advise would be greatly appreciated guys...
Welcome to HPISavageForum, a friendly forum to discuss the Savage RC Truck.
Your voice is missing! You will need to register to get access to the following site features:We hope to see you as a part of our community soon!