Well, I've fitted the K-Factory CB, but have gone back to using the original HPI plastic spur. I know this may sound silly as you don't need to run a hardened CD with a plastic spur but I must say that i'm suprised at how well the plastis spur is holding up. I've ran about 10 tanks through and...
Taken from Wiki..............
Acetone, which is sometimes found in nail polish remover, is a commonly available solvent capable of softening cured cyanoacrylate. Nitromethane is also an excellent solvent. Methylene chloride is the most effective but is toxic.
I've ordered a couple of K Factory clutch bells? Anyone have any experience with these. Are they any good? I THINK they are hardened. Can anyone confirm this. I assume that the HPI one's are NOT hardened, is this right?
I'll try it with the plastic spur as soon as I get the new bell and bearings.
I'll also re-set the slipper spring to 1/2 turn.
I'm wondering if anyone else who has used a steel spur/bell has suffered this problem before.
Hi guys, been looking in for a while now but only just registered. Bought a used Savage about a month ago. Put a new STS .28 engine in it but it's VERY quickly going through clutch bells.
Am using a 47T spur and have gone through 2X 18T and 1X 15T. Each bell is only lasting about 2 tanks...