Recent content by savagebasher13

  1. S

    My Brushless Savage Conversion

    Uh Oh Can sombody delete post 7 and 8 and 9?
  2. S

    My Brushless Savage Conversion

    I got some pics: Battery tray:http://s368.photobucket.com/albums/oo127/traxxasbasher13/?action=view&current=P1010457.jpg Truck with battery trays and old servo plate:http://s368.photobucket.com/albums/oo127/traxxasbasher13/?action=view&current=P1010463.jpg...
  3. S

    My Brushless Savage Conversion

    The Direct Drive setup is very simple. I took 1/4 in lexan and cut it into 7 1/2 cm by 6 cm. then when I get my motor I will cut holes in the lexan on both sides and screw the motor to it. After that I will install RCM 8mm drive cups to the shaft and install the driveshafts. Then I hook it up to...
  4. S

    My Brushless Savage Conversion

    The Direct Drive setup is very simple. I took 1/4 in lexan and cut it into 7 1/2 cm by 6 cm. then when I get my motor I will cut holes in the lexan on both sides and screw the motor to it. After that I will install RCM 8mm drive cups to the shaft and install the driveshafts. Then I hook it up to...
  5. S

    My Brushless Savage Conversion

    The Direct Drive setup is very simple. I took 1/4 in lexan and cut it into 7 1/2 cm by 6 cm. then when I get my motor I will cut holes in the lexan on both sides and screw the motor to it. After that I will install RCM 8mm drive cups to the shaft and install the driveshafts. Then I hook it up to...
  6. S

    My Brushless Savage Conversion

    I'm just using an outrunner in between two 1/4 in lexan pieces. Then I will use two RC Monster 8mm drive cups on the motors shaft and put the dogbones in. Its really simple and cost effective. RCM drive cups:http://www.rc-monster.com/proddetail.php?prod=RCM8mmdrivecup I got pics...
  7. S

    My Brushless Savage Conversion

    An outrunner.
  8. S

    My Brushless Savage Conversion

    Thanks! I'll keep you guys updated.
  9. S

    My Brushless Savage Conversion

    Hey guys. I've had a savage for about a year, but I couldn't take the nitro BS. I have gutted it and now I'm ready to convert it to brushless. I'm going to have a Direct Drive setup with an outrunner and a MMM. It will run off of 5-6s 4500mah lipos for speeds up to about 46mph. The MMM is a...
See more
Back
Top