Recent content by ROCKO9865

  1. R

    Roll Cage

    I will try the mc8 and see how it does. never thought of the glow plug explains a lot! book marked that site to! thanks for the help!
  2. R

    Roll Cage

    I'm running stock picco temps climb up to 280 to over 300 if I'm not care full and keep an eye on it. richen it to the point were any more would give poor performance. run a mc59 glow plug. but with the body off i can get through a tank and temps would be around 275 to 285 and run great. seems to...
  3. R

    Roll Cage

    hello i was looking for a roll cage for my savage xl. when i run with the body on and holes cut out i still run hotter than when the body is off. no matter how i tune it runs hot with the body so was looking for some feed back on which roll cage would be best i like this one but pricey...
  4. R

    universal drive shafts

    good info thanks!! i will stay with the original dog bone then!
  5. R

    universal drive shafts

    looking to up grade to universal drive shafts for my xl does anyone know if these are good? and what would the purpose of reverse threads be for? here is the link check it out. http://myatomic.com/catalog/viewsku?sku=HBS61152&itemname=drive_shafts_savage_2_
  6. R

    Radio system

    wow! looks like everyone likes the futaba 3pm think i will look into that one maybe ebay has one cheap. thanks!
  7. R

    Radio system

    All right now that spring is finally here i want to up grade my radio system looking to replace servos as well is there any combo system that is out there. looking to spend around 200 to 250 if possible any suggestions would be great!
  8. R

    Picco .28 Drag mod

    Yea mine was the same way and i left it alone and it fired right up! did not touch any settings for about 5 to 6 tanks in! just today i started tuning a little but the pinch is still tight! takes patience with these motors thats for sure!! had mine for 2 weeks now.
  9. R

    glow plug for picco

    For those who have a picco.28 what glow plug do you use? I'm running 25% byrons, and a mc 59 glow plug. still in my break in mode. once broke in should i stay with this plug or try another one?
  10. R

    tranny sliping

    I'm thinking it is the oneway because i have a new pad new 47 tooth spur new tranny that has been used maybe 7tanks or so and like i said when i had it apart a week ago noticed oil on the shaft were the one way sits wiped it and still slipping but it seems worst than before.
  11. R

    tranny sliping

    ok ill do that but you know when you take the gears out of the tranny are they really wobbly all three on mine are like that. i don't think thats right can anyone confirm this?
  12. R

    tranny sliping

    ill check it but when i put the tranny in i tightened it all the way and loosened one quarter turn. takes off strong it just tries to shift and revs up until rpm goes down but will check. thanks! hopefully i can find stock settings for the shift point may have it out of spec oh yea and when it...
  13. R

    tranny sliping

    was breaking in my new engine today and on the 5th tank when i was driving it is now trying to shift as the engine is breaking in. problem is when it shifts it don't always grab it free spin then when the rpms come down it will grab does this alot. do you think it is the oneway bearing on the...
  14. R

    picco fly wheel nut

    yea what i did was tightened it to the fly wheel with out over tightening then back out again and every thing looks good and was easier to go back on than the first time so think i am ok! think there might have been some debri inside the nut it self it was used on my lrp engine probly had some...
  15. R

    ofna pipe question

    ok thanks i have the o86 ofna pipe and put the same gasket that goes to the engine/header and conected the header to pipe with same type gasket plus the 3 springs and it fits really nice! i guess thats right?
See more
Back
Top