Recent content by Lancestewart2

  1. L

    What are your thoughts?

    Well I took it out today and had a couple of issues: 1) Even though I had the settings stock, the car would rev a bit when releasing the throttle. I think this may have been due to either ritch settings or high idle which follows onto issue 2. 2) I had an idle issue, it would only idle at...
  2. L

    What are your thoughts?

    Well I took it out today and had a couple of issues: 1) Even though I had the settings stock, the car would rev a bit when releasing the throttle. I think this may have been due to either ritch settings or high idle which follows onto issue 2. 2) I had an idle issue, it would only idle at...
  3. L

    What are your thoughts?

    I don't have a temp gun so was only going by touch, so in fairness it may have been ok just at the higher end! The rain was quite hard with spray from the tires too. Normally my plugs last ages too, but it seemed to blow when the tank had finished. I'm hoping to take my car out soon, so...
  4. L

    What are your thoughts?

    Thanks guys, Thankfully there were no puddles, but it was raining and I had the body off. This is the second engine I've had to run in, all others were second hand used ones with used internals, so I think it's my lack of knowledge here which has made me concerned when the engine did something...
  5. L

    What are your thoughts?

    Hi guys! I put a new piston liner, piston and Conrod into my hpi 4.6 engine today, I did 2 tanks at idle, and 2 tanks less than half throttle driving in circles, all was running great during the break in period, but during the last run it started to rain, the engine seemed to lose power at...
  6. L

    Clutch bell and spur alignment issue after .36 upgrade

    Thank you for your reply :-) I'm using an hpi 47t steel spur and hpi hardened steel 17t clutch bell. That motor mount sounds perfect for resolving this issue! I'll have a look around the net for one. The flywheel is definately attached correctly. I think I may look at purchasing a new...
  7. L

    Clutch bell and spur alignment issue after .36 upgrade

    Hi guys, The Savage is a new toy for me and so far I'm really impressed with it, it started off as a Savage 21 but I've upgraded the diff, clutch bell and spur gear to accommodate a force .36. The engine is great but the spur and clutch bell done line up right, the spur gear over hangs...
See more
Back
Top