thanks for all the help everyone.
I am running bryons nitro fuel 20%.
I just got a new one way bearing today, so I'll soak it in wd 40 and let it ride. I'll also do what fuel father said..with the glow plug trick.
I have had my savage for about a month and my one way bearing already went out. I hear from somewhere it is due to the pressure that builds up inside the engine when starting. so in this situation I have 2 questions:
1. Should I take the glow plug out and use the rotostart for 2 seconds to try...
Thrasher where do I get a spektrum and which one is the one for savage x?
last question, is it a pain in the arse to put in. I am at the site right now, so it looks like I'd have to get a new remote as well.
I was running my savage at work, and did a wheelie that flipped the care over and got my antenna cut,about an inch worth. Does anyone know what I need to replace the radio part in the car?
For now I haven't seen any trouble or any differences in control. My buddy had his sheered off by 4 or 5...
My radio remote antenna broke in the second to last section towards the peak of the antenna. I did the jerr rig thing and made it fit back in and it works fine but I don't want it like that forever. Does anyone know the replacement part? Or should I wait and uprgrade to a better remote?
Thanks...
I ran my savage today, 2 tanks worth, and the temp peaked at 205. It was about 6 pm and 77 degrees outside. I had a bit of thin smoke coming out, but had that nice smell of the 20% fuel coming from the exhaust.
I am wondering if I should of leaned it a bit, for future use, but it ran great.
My servo doesn't go into the nuetral position like it says in the book or like in probers pics in the post above, it is about 1 cm off. Any idea how to fix that?
Aslo from the pics, I put some fuel line between the spring and screw, but I see that prober replaces the spring completely. Which...
I am going to just ask my option parts questions here so I don't start any more threads, hope it is ok with everyone.
Question that is on my mind right now is, what charges a hump pack? I am thinking of getting one, but can't find a charger for it on towerhobbies.com.
Is it the same charger...
Good tips, I will be sure to use the liquid ratio issue. I just bought some after run spray and used most of the bottle, but then again it was pretty dirty due to little bit of mud.
I used a toothbrush to get some of the mud and dirt off, and it workd out pretty good. I also cleaned the air...
Thank for the tip monkey. I am getting my temp gun tomorrow via ups. When I use my friends gun, I try to keep the temp under 250, but now I'll keep it under 260. If it goes over, other than riching the high speed, from I am told, what esle can I do? Turn it off let it cool down?