Spur Gear Bearing

[EAC-ISR]

Anyone Knows The Bearing Size For The Spur Gear?i Wanna Change The Brass Thing To A Bearing.thanks

[Droogmole SS 4.6!]

why do you wanna do that??...you will only losen up the slipperclutch..its not supposed to turn freely..??

[EAC-ISR]

I Had One On My Old Savage Before,and It Work Good It Reduces Friction And It Will Help For A Smoother And Faster Acceleration.

[TH3180]

I think I am missing something here why would you want a bearing on something that should only turn when the slipper is ingauged. Don't get me wrong to each his own I just don't understand the benifit in putting a bearing in where the brass piece is

[RAZORROGERS]

sounds crazy to me coz i have mine locked up tight anyway

[ACE]

I don't know the number but the bearing that you take out a tmaxx when doing foward drive only works great. as much as i hate to say tmaxx.

[windjammr]

just make sure its the same thickness or the slipper wont engage

[Lunar Wolf]

OD=11mm
ID = 5mm
W = 4mm

I did that and it had less wobble then with the brass bushing, that and when it did start slipping alot due to a bad nyloc nut i only burnted out the pad and not the centre of the spurgear.

[Doesgo]

It is 5x11, but isn't it 3mm thick? I tried a 4mm but it wouldn't sit flush with the face of the spur gear.

[Lunar Wolf]

B072 (http://www.hpieurope.com/piw.php?lang=en&partNo=B072) is the part your replacing, if you couldn't get a bearing of the same size to fit you either didn't have the bearing you thought you did or you need to push harder.

[Jeremy]

So what would this bearing do any help by doing this ?

[Doesgo]

B072 (http://www.hpieurope.com/piw.php?lang=en&partNo=B072) is the part your replacing, if you couldn't get a bearing of the same size to fit you either didn't have the bearing you thought you did or you need to push harder.

Yep, must not have pushed hard enough! LOL!