Homemade skidplate

[HPI_Savage25]

I was wanting to make a skid but don't know what to use to hlod it to the frame? i thought about a pop-ribit but then it would be hard to remove and then thought about regular screws..... what do yall think... it's for the middle:confused:

[Chaos]

buy 2 more of those plastic braces that go acroos the frame at the back of both front and back skids...then you will need 8 screws..4 for each bar(2 to the TVP's and 2 into the skid it's self)..and it should mount up and easy to remove as it's just screws holding it on.

[Droogmole SS 4.6!]

http://i67.photobucket.com/albums/h287/Droogmole/DSCF0365.jpg
http://i67.photobucket.com/albums/h287/Droogmole/DSCF0366.jpg
i made mine like this its just screwd on the cross bars.. i've bin bashin it pretty hard last time and it didn't came lose or something..
currently i'm building a front and rear bumper to from 4MM alu .. my first bumper is almost finished.. it looks great.. can't wait till my savvy is all alu from underneath( is that correct??)

[HPI_Savage25]

how about this: made it today!:)


See 3 posts down for a better pic ;)

[Hoppedup Savage]

what kind of steering servo is that, just noticed it wasent a stocker

[3speedlightning]

found out somethin i didnt know.......how to resize images..........thanks

[HPI_Savage25]

well to be hones I really dont kow hopped all i know is it is metal gears and i paid 50 bucks for it andhaven't had any problems.

[HPI_Savage25]

http://i112.photobucket.com/albums/n188/HPI_Savage25/100_0497-1.jpg hope this is better

[HPI_Savage25]

ok My steering servo is a Hobbico Commander Super Torque CS 70. if that helps any Hopped .. also thanks X

[jdogg_js_here]

What did you use to make your skidplate?

[HPI_Savage25]

I Used Some Thin Metal And The Stock Screws Along With A Drill And A Hammer..it Was Easy