New Member

[NvSavage]

Hey guys, Just thought I would throw a hello out to all of you here. I am a new member and also a new Savage X owner as of yesterday. 1st one for me, so looking forward to the experiance. Hope to talk to you all soon, and I'm sure I will have lots of questions down the road.

[guest]

NV-welcome to the forum. fire away with any question u have....

[NvSavage]

Thanks for the welcome savagefano4. Take you up on a question: The mannuel says to run 30% Nitro. I have a gallon of 20% left over from my other truck, So could I finish out the 20% on the savage(brake in and run) and then switch over to 30%. Or will this hurt the Mill. I hate to let the 20% just sit there, sold the other truck, so no need for it now. Also, should I brake the new mill in with the inner cone on the pipe installed or take it out. I figure if I leave it in, it might just build up combustion. And not get a proper breck in. Is it really annoying with the cone out. Thanks again.

[SAVAGEfan06]

I am a new member also.

[NvSavage]

I am guessing that the 30% is gonna make it run a little hotter and have more engine wear. If I run the 20% and then go to the 30% I'm sure it would probably require more tunning also.

[RCDad]

I run O'Donnell 30%, only difference I see is how much easier the engines are to start, tune, and run.

[savagekicknmaxx]

I am guessing that the 30% is gonna make it run a little hotter and have more engine wear. If I run the 20% and then go to the 30% I'm sure it would probably require more tunning also.

It will actually make it run a tad cooler 30% makes more power hence you can run a tad richer there for cooler. You can start with the 20% then move up to the 30%. When you switch you will have to go through a short rebreakin with the 30% to get the motor broke in to the 30%. I started with 20% in my savvy with first gallon then jumped to 30% and with a port and polish of the sleeve, it now really runs good. Also these bigger motors like cold plugs, run better.

[HPI_Savage25]

hoiw much cooler does it run with the 30 than with the 20

[savagekicknmaxx]

I noticed on mine that the change in temp was about 10-20 degrees cooler pending on outside ambient temp and needle settings, and how hard you run it. Mine when set I kept it the same temp as it was with 20% so I could have a little more increase in power.

[R6 DADDY]

was there much more power or just a bit ??

[4x4]

welcome to the site
4x4