Underfall
05-11-2010, 11:35 PM
This is a work in progress so......
Started with a piece of plastic for a platform.
http://i40.tinypic.com/ta3aqx.jpg
Next I carefully dissected the stock battery/servo box as follows,
and saved certain parts of it for later use. (With a hacksaw.)
http://i41.tinypic.com/izsxz7.jpg
http://i39.tinypic.com/25g5dw5.jpg
http://i42.tinypic.com/wrdor6.jpg
I cleaned up the pieces on my grinding wheel for a smooth finish.
You can start to see where I am going with this.
http://i42.tinypic.com/sgj0ht.jpg
Next I started fitting in the platform and steering servo.
http://i41.tinypic.com/2ujrry9.jpg
Keep in mind this is mocking it up for fitting, this set up is subject to change.
http://i44.tinypic.com/2ibeo3d.jpg
Next I turned my attention to the throttle servo.
http://i41.tinypic.com/246s008.jpg
Using the box cut and saved from the stock part at the beginning,
I plan to mount the servo nice clean and safe next to the engine.
http://i40.tinypic.com/2ep61yr.jpg
http://i40.tinypic.com/2e1soxg.jpg
http://i43.tinypic.com/rlwe2u.jpg
Build time so far including this post was about 1 hour and a half.
Have to be up early for fieldwork, so its time to pack it in for the night.
I will post more as I go, still have to buy a Ofna tank.
I have to admit I am having a blast with this contraption.
All comments and questions welcomed.
-Bri
Started with a piece of plastic for a platform.
http://i40.tinypic.com/ta3aqx.jpg
Next I carefully dissected the stock battery/servo box as follows,
and saved certain parts of it for later use. (With a hacksaw.)
http://i41.tinypic.com/izsxz7.jpg
http://i39.tinypic.com/25g5dw5.jpg
http://i42.tinypic.com/wrdor6.jpg
I cleaned up the pieces on my grinding wheel for a smooth finish.
You can start to see where I am going with this.
http://i42.tinypic.com/sgj0ht.jpg
Next I started fitting in the platform and steering servo.
http://i41.tinypic.com/2ujrry9.jpg
Keep in mind this is mocking it up for fitting, this set up is subject to change.
http://i44.tinypic.com/2ibeo3d.jpg
Next I turned my attention to the throttle servo.
http://i41.tinypic.com/246s008.jpg
Using the box cut and saved from the stock part at the beginning,
I plan to mount the servo nice clean and safe next to the engine.
http://i40.tinypic.com/2ep61yr.jpg
http://i40.tinypic.com/2e1soxg.jpg
http://i43.tinypic.com/rlwe2u.jpg
Build time so far including this post was about 1 hour and a half.
Have to be up early for fieldwork, so its time to pack it in for the night.
I will post more as I go, still have to buy a Ofna tank.
I have to admit I am having a blast with this contraption.
All comments and questions welcomed.
-Bri