Idle probs

[HPI_Savage25]

Hey guys I am having probs with the STS's idle. IT starts fine but then it just goes nuts. Any help is appreciated

[wullie]

i had the same problem with my sh .28. its an airleak. get some high temp gasket sealant and seal the plate on back at 1 way bearing, seal the carb in the engine and seal either side of the nut and bolt that holds the carb in the block (pinch bolt). then check your fule lines and tabk are airtight. i done this and all my idle and erratic rev problems went away.

have a read through this http://www.hpisavageforum.com/forums/showthread.php?t=1377&highlight=engine+sealing this was my thread when i had the problem and theres alot of good advice here from guys on the site. (thanx again guys!)

[wullie]

any better?

[HPI_Savage25]

Oh sorry lol. Ya i found an air leak at the HSN. I fixed it then my OWB sliips some much i went thru a entire battery trying to get it to turn over...:( gonna drop a S-25 backplate and roto-start in if it will work. Thanks