clutch bell

[4x4]

would any one know if the clutch bell is surposed to judder backwards and forwards on idle.it doesn't fall off though.is this normal?
thanks 4x4

[Jeremy]

make sure u have all the washers on the bell make sure its not to loose.. I know that the stock brass washer that comes with the mill gets all buggerd up and causes allot of slop so now I just use like 3 washers u might have to grind one down so it doesn't fit too tight

[Doesgo]

Yeah, there should be a very small amount of forward/rearward play along the crank, but not enough that you can see it while running.